Are the the rocker panel moldings the same for a 2dr vs a 4dr?
Forum: Corvair Center Forum

Still have hesitation to the point stalls some times when shifting to drive or reverse.I corrected the vacuum lines, synced carbs per shop manual, retimed, checked dwell, vacuum gauged it, rechecked fuel filters and flow. I have an engine that sometimes stalls putting into gear, and if not that hesitates, cutout at will...What next???
Forum: Corvair Center Forum

Will be a few weeks before I get to check those lines, I will let you know. Thx
Forum: Corvair Center Forum

A followup to all the inputs suggested: Accelerator pump checks ok- good spray , points appear to be ok, adjusted timing, no vacuum leaks observed. Did free up choke, tried it with chokes half closed, seem to run fine. So with no vacuum leaks that I can find, what specifically should I check on the carbs?? The vacuum line from each carb that runs down under the covers goes specifically to what?
Forum: Corvair Center Forum

Have a good sprayin both carbs. Haven't had the car long, do you think the carb floats could be set wrong?
Forum: Corvair Center Forum

what is the best way to check accelerator pump?
Forum: Corvair Center Forum

Hello, can't use choke at the moment as the cable is frozen.It is on my list of things to correct. Will let you know as soon as I know on this one. Thank you
Forum: Corvair Center Forum

As described, starts and runs well when cold. As soon as warmed up, hesitation will occur, especially when loading it up on a hill, etc. Have placed a resistor in the resistance wire line as someone previously spliced into the line. Changed the coil, checked timing, points, plugs. Not sure where else to go with this. Thx, Corvaddict
Forum: Corvair Center Forum