Corvair Center Forum : Corvair Center Phorum
After Market Steering Wheel Question
Posted by: SoloCP ()
Date: May 13, 2018 06:14PM
I bought a Grant Wheel at our yearly Corvair Benefit Auction, The wheel had been previously installed on a Corvair so I know it wheel fit with the proper adapter.
My question though is I want to install this on my Corsa Race Car which has a Telescoping Wheel, I am not worry if installing the wheel disables the Telescoping as long as it does not ruin the column. I was thinking about removing the Wood Wheel and remove the Grant Wheel from its spacer and installing the wheel just as the wood wheel is attached which would leave the telescoping section intact. If this is not possible what is the best way to mount the steering wheel. The only reason I am changing is the wood wheel flexes during hard corning. Pics attached of what I have
Broken Halo Corvair Garage.
62 Monza aka (Flicka)
63 700 Sedan 3 Speed
64 Spyder Coupe (Bill Pierson Car)
64 Monza Convertible,140/4 Speed,Electric Heat,Kelsey Hayes Wheels
64 Spyder Blown, (Dave Bolduc Car)
64 Monza Convertible 110/Auto (Future Project)
65 Corsa 3.1 Liter Triple Weber (aka Unsafe)
65 Corsa 140/4 Speed with Triple Weber
66 Avenger, Corvair Turbo, Fuel Injected, Air to Water intercool 140. (Michael Mann Car)
67 Monza 110 Auto. Sugar Bear
Re: After Market Steering Wheel Question
Posted by: cnicol ()
Date: May 13, 2018 06:43PM
What you're proposing should work but the Grant wheel is 5-bolt and the GM wheel is 6-bolt. You'll have to look at the parts and figure out whether the hub or the wheel gets modified. I suspect it's going to be the wheel.
Craig N. Coeur d'Alene ID.
66 Black Monza 4dr, 4.2L V8 49k
61 Seamist Jade Rampside 140 PG
60 Monza coupe (sold, sniff sniff)
66 Sprint Corsa convt - First car! Re-purchased 43 years later
2+2 gnatsuM 5691
+17 Tons of parts