Corvair DiagramCorvair Photo
Corvair Center
home forum corvairs calendar links Corvair Podcast
California Corvairs
Clarks Corvair
Clarks Corvair
“Performance
“CORSA"



Chevy Corvair License Plate
Chevy Corvair Chrome Wheel
Corvair Center Forum :  Corvair Center Phorum The fastest message board... ever.
Corvair Center 
clutch adjusting rod question
Posted by: Murphy ()
Date: January 11, 2018 11:59AM

Sorting through boxes of "stuff" today, I came across a clutch adjustment rod, and I noticed it is a larger diameter than the one used on my '61 coupe.

Can someone tell me if the Vans/Pickups use the larger rod or is this for a LM?

I didn't measure anything, I can tell just by looking at it that the one I found is larger in diameter. Sorry, no pictures either.

Thanks

65 Monza Coupe
61 500 Coupe (under Construction) Getting close.

Options: ReplyQuote
Re: clutch adjusting rod question
Posted by: steve c goodman ()
Date: January 11, 2018 12:55PM

Is threaded end the same 3/8" but larger towards the release brng fork end? If si it is 65-up. Early used same 3/8" diameter from end to end.

best wishes, Steve
Rear Engine Spec. Inc. Golden, Colo.

1962 spyder 3.0L turbo 1965 Crown V8
1967 monza 110/4 1968 monza 110/4
1971 amante gt 110/4
CORSA/RMC/PPCC

Options: ReplyQuote
Re: clutch adjusting rod question
Posted by: RobertC ()
Date: January 11, 2018 01:00PM

According to parts book, there are 4 rods (4 different part numbers):

60-64
61-62 F.C.
63-65 F.C.
65-69

Options: ReplyQuote
Re: clutch adjusting rod question
Posted by: Murphy ()
Date: January 12, 2018 03:37AM

Thanks for the info Gents.

65 Monza Coupe
61 500 Coupe (under Construction) Getting close.

Options: ReplyQuote


Sorry, only registered users may post in this forum.
This forum powered by Phorum.