Corvair DiagramCorvair Photo
Corvair Center
home forum corvairs calendar links Corvair Podcast
California Corvairs
Clarks Corvair
Clarks Corvair
“Performance
“CORSA"



Chevy Corvair License Plate
Chevy Corvair Chrome Wheel
Corvair Center Forum :  Corvair Center Phorum The fastest message board... ever.
Corvair Center 
LM Corsa Rear window
Posted by: gnrand ()
Date: January 08, 2018 04:12PM

Trying to figure out how the headliner terminates at the plastic trim. I would really appreciate if someone could provide a picture of this area.
Thank you
Jeff

Wildomar,Ca

1965 Corsa Hard Top
!965 Corsa Convertible
1968 Monza 140 Convertible 4 speed
1966 435 HP Crown
1986 Buick GN

Options: ReplyQuote
Re: LM Corsa Rear window
Posted by: RobertC ()
Date: January 08, 2018 04:27PM

Here is one - no difference in headliner between Monza and Corsa:

Attachments:
Options: ReplyQuote
Re: LM Corsa Rear window
Posted by: TerribleTed ()
Date: January 08, 2018 04:44PM

Headliner is glued around the metal flange and then the plastic trim is installed over it pinching it to the flange.

---------------------------------------------------------------------------------------------------------

Avid Corvair hobbiest since 1984.
I have personally performed ground up restoration on over 20 Corvairs.
I currently work full time at restoring and repairing Corvairs.
Located in the Atlanta Georgia area.
[www.facebook.com]

Options: ReplyQuote
Re: LM Corsa Rear window
Posted by: gnrand ()
Date: January 08, 2018 05:40PM

Thank you. Is the wide side without the channel the side that contacts the headliner.

Options: ReplyQuote
Re: LM Corsa Rear window
Posted by: RobertC ()
Date: January 09, 2018 08:51AM

gnrand Wrote:
-------------------------------------------------------
> Thank you. Is the wide side without the channel
> the side that contacts the headliner.

Do not understand your description - been years (decades?) since I have had the rear trim out.

You might not understand my description:

The headliner is folded around the "most interior" pinch weld. My personal opinion is that it should be just around the pinch weld and not further into the "gap".

The rear window sits in the outer lip. You do not want the headliner contacting this area.

But, I have never installed a headliner. Based on my skills (non-existent) in this area , I figured it was cheaper to pay someone.



Edited 1 time(s). Last edit at 01/09/2018 08:57AM by RobertC.

Options: ReplyQuote


Sorry, only registered users may post in this forum.
This forum powered by Phorum.