Corvair DiagramCorvair Photo
Corvair Center
home forum corvairs calendar links Corvair Podcast
California Corvairs
Clarks Corvair
Clarks Corvair
“Performance
“CORSA"



Chevy Corvair License Plate
Chevy Corvair Chrome Wheel
Corvair Center Forum :  Corvair Center Phorum The fastest message board... ever.
Corvair Center 
What type of screw is used for the '65 turn signal lever?
Posted by: Sir Thomas ()
Date: December 02, 2017 12:06PM

Pretty straight forward question as the Subject line implies: What type of screw is supposed to be used to secure the '65 turn signal lever to the turn signal assembly? (standard non-telescoping column)

A picture would be very helpful if possible.

Thanks,

Thomas Ratliff
Marion, Indiana
Fitch Sprint (in progress)
'66 Monza convertible with EFI
thomas.ratliff@indwes.edu

Options: ReplyQuote
Re: What type of screw is used for the '65 turn signal lever?
Posted by: Lane66m ()
Date: December 02, 2017 02:07PM

A washer head machine screw (1/4" head). threads diameter is #8, I believe. length is about 1/4 inch. not home where I could snap a photo. If someone doesn't clarify by tomorrow evening I will post a photo. I just installed Roger Parent's prototype turn signal lever in my 66 Monza, so it is stll fresh in my memory.

Al Lane
Ellabell GA

1966 Monza Coupe, 110 hp, 4 Spd
1966 Corsa Turbo Coupe, 180 hp 4 Spd
1964 Greenbrier Deluxe, 6 dr, 80 hp car engine, PG
2015 Chevrolet Malibu 2LT
2015 GMC Sierra SLT Crew Cab
1968 Camaro SS Coupe 350 CI 295+ HP PG
1947 Farmall A tractor 15 hp


Options: ReplyQuote


Sorry, only registered users may post in this forum.
This forum powered by Phorum.