Corvair DiagramCorvair Photo
Corvair Center
home forum corvairs calendar links Corvair Podcast
California Corvairs
Clarks Corvair
Clarks Corvair
“CORSA"



Chevy Corvair License Plate
Chevy Corvair Chrome Wheel
Corvair Center Forum :  Corvair Center Phorum The fastest message board... ever.
Corvair Center 
What type of screw is used for the '65 turn signal lever?
Posted by: Sir Thomas ()
Date: December 02, 2017 12:06PM

Pretty straight forward question as the Subject line implies: What type of screw is supposed to be used to secure the '65 turn signal lever to the turn signal assembly? (standard non-telescoping column)

A picture would be very helpful if possible.

Thanks,

Thomas Ratliff
Abilene, Texas (NEW transplant from Indiana)
'65 Fitch Sprint (very nearly completed)
'66 Monza convertible with EFI
ThomasMRatliff@yahoo.com

Options: ReplyQuote
Re: What type of screw is used for the '65 turn signal lever?
Posted by: Lane66m ()
Date: December 02, 2017 02:07PM

A washer head machine screw (1/4" head). threads diameter is #8, I believe. length is about 1/4 inch. not home where I could snap a photo. If someone doesn't clarify by tomorrow evening I will post a photo. I just installed Roger Parent's prototype turn signal lever in my 66 Monza, so it is stll fresh in my memory.

Al Lane
Ellabell GA

1966 Monza Coupe, 110 hp, 4 Spd
1968 Camaro SS Coupe 350 CI 295+ HP PG
1964 Greenbrier Deluxe, 6 dr, 80 hp car engine, PG
2015 Chevrolet Malibu 2LT
2018 Chevrolet Silverado LTZ Z71 Centennial Edition
1947 Farmall A tractor 15 hp


Options: ReplyQuote


Sorry, only registered users may post in this forum.
This forum powered by Phorum.