Corvair DiagramCorvair Photo
Corvair Center
home forum corvairs calendar links Corvair Podcast
California Corvairs
Clarks Corvair
Clarks Corvair
“Performance
“CORSA"



Chevy Corvair License Plate
Chevy Corvair Chrome Wheel
Corvair Center Forum :  Corvair Center Phorum The fastest message board... ever.
Corvair Center 
EM front suspension questions
Posted by: kaminski45 ()
Date: August 08, 2017 03:26PM

I am rebuilding the front suspension on my 64. When I took it apart I forgot to record what shims were where for the camber. Is there a general spec that should be used as a base line or just put an equal amount in on both sides? Also is the a length the control rods should set to?

Options: ReplyQuote
Re: EM front suspension questions
Posted by: MattNall ()
Date: August 08, 2017 03:52PM

That's done when it's aligned..





MODERATOR
Sea Mountain, between Charleston Harbor and Coos Bay! SW Oregon Coast
Click HERE for My Website...Click HERE for My TechPages!
..............................110-PG.................................................Webered-Turbo

Options: ReplyQuote
Re: EM front suspension questions
Posted by: kaminski45 ()
Date: August 08, 2017 06:12PM

I understand that this will all be done when the alignment is done but I'm just looking for some numbers to put on the car so it's kinda close.

Options: ReplyQuote
Re: EM front suspension questions
Posted by: MattNall ()
Date: August 08, 2017 06:28PM

After the car is back together... roll it forward and backwards a few times...

Take a 2 ft Level and hold it against the sidewall vertically....add shims to get the bubble mostly to the outside of the line.





MODERATOR
Sea Mountain, between Charleston Harbor and Coos Bay! SW Oregon Coast
Click HERE for My Website...Click HERE for My TechPages!
..............................110-PG.................................................Webered-Turbo

Options: ReplyQuote


Sorry, only registered users may post in this forum.
This forum powered by Phorum.