burp

South Carolina Upstate



68 Monza convertible 140 4spd A/C (coming soon)
66 Corsa coupe 140 4spd

Cole:

You can build your own with 2 large steel washers and a piece of iron pipe to take up the gap. All should be slightly larger in ID than the axle shaft OD.

Al
Georgia

coleslaw31 Wrote:
-------------------------------------------------------
> Hey what is this and is it possible to still get
> one?
>
> Also what is the size of the castle nut? Mine
> didn't was met with a torch.
-------------------------------------------------------
That is a Beer Tool! That top spacer is a axle yoke cut off and turned down on a lathe to make it easy to torque when checking clearance.







1960 4dr sedan caveman car
1961 Rampside (Chetside)
1962 Rampside (Barnside)
1962 Short Rampside (Shortside)
1962 Monza 700 Wagon
1963 Monza 900 coup (General Nader)

-----------------------------------
Rust Free Lancaster Ca

Understood on the special lubricant in the brown container. I do lubricate myself with a couple containers of the lubricant from the mountains every now and then.

The item in the circle was what I was referring to. It is a machined spacer to take the place of the axle yoke. The washers and thick wll pipe can be used to do the same task, if you can't find someone to make you a spacer.

Al
Georgia

Awesome thanks guys! I have mine heading to my lathe man to get everything made into the tool. Now I just need a 6 pack to complete my setup!

South Carolina Upstate



68 Monza convertible 140 4spd A/C (coming soon)
66 Corsa coupe 140 4spd