………
![]() ![]()
| |||||||||||||||||||
![]() ![]() ![]() ![]() ![]() ![]() |
Corvair Center Forum :
Corvair Center Phorum - presented by CORSA
![]() Corvair Center WTB Carb. Linkage Piece Posted by:
J.Pennell
() Date: March 20, 2023 08:37PM My goof on the choke rod mention. I meant to say the groove is the same as the end of the short rod that connects the vacuum diaphragm (choke pull-off) to the choke shaft actuating lever. Jim Edited 1 time(s). Last edit at 03/21/2023 10:42PM by 1966-Corsa-GT-180. Re: WTB Carb. Linkage Piece Posted by:
RobertC
() Date: March 21, 2023 01:28AM Confused? Are you talking about the short rod that attaches to the choke pull-off? You do not say where you are? A local club member probably has a spare one. Corvair Ranch probably has them. Clark's sells "new" / reproduced ones. Re: WTB Carb. Linkage Piece Posted by:
Phil Dally
() Date: March 21, 2023 01:59PM Jim is looking for the 1968-69 only style of #6 shown in the picture below. Throttle adjustment rod with threaded bottom and e-clip on the top end. Driver side as the passenger side does not have the threaded adjustment. 1968-69 only e-clip style...not the 1965-67 loop slip over snap in place. Attachments: ![]() Re: WTB Carb. Linkage Piece Posted by:
RobertC
() Date: March 21, 2023 02:09PM Good luck on that... California Corvairs has the 65 - 67 version used. Corvair Ranch? Re: WTB Carb. Linkage Piece Posted by:
Timothy Shortle
() Date: March 21, 2023 02:50PM Wouldn't that part be the same as a 2 carb. engine (since it is the primary carb.)? Re: WTB Carb. Linkage Piece Posted by:
RobertC
() Date: March 21, 2023 02:59PM Timothy Shortle Wrote: ------------------------------------------------------- > Wouldn't that part be the same as a 2 carb. engine (since it is the primary carb.)? Just using a picture (Clark's catalog?) to indicate type of link... 68 - 69 driver's side primary carb uplink / rod from throttle lever to cross shaft? Re: WTB Carb. Linkage Piece Posted by:
Phil Dally
() Date: March 22, 2023 07:13PM FOUND Thank you Mr. Goodman!! Sorry, only registered users may post in this forum. |