The LM ignition switch bezel nut came in to different heights with FOUR indentations for an install/remove tool.

After lousy luck with some of the tools that didn't work well to remove the bezel nut I found this tool that works great. It can apply enough torque for removing a stubborn bezel without slipping and damaging the chrome.

See [www.ecklers.com]



Edited 1 time(s). Last edit at 04/01/2021 05:26PM by 66vairman.

Did you try the BlueChip tools unit. Russ does a great job.

[www.bluechiptools.com]

Seth Emerson

Check my new Performance Corvair Web site [www.perfvair.com]

I go to order the tool yesterday, and find out it's a 4 prong job and I have a 3 pronger : This is one good reason I don't play lotteries. I can't win crap. Good April fools joke on me.



Edited 1 time(s). Last edit at 04/04/2021 05:08PM by MattNall.

Yes, Seth, Russell's tools work very well.

Frank DuVal

Fredericksburg, VA

[www.ebay.com]



MODERATOR
Sea Mountain, between Charleston Harbor and Coos Bay! SW Oregon Coast
Click HERE for My Website...Click HERE for My TechPages!
...............110-PG.................................................Webered-Turbo

Russ's ignition tool has special "movable" prongs for the out side. It can be used with 3-prong or 4-prong ignition bezels. I even have a suggested mod to make it work even better! If you have one of his ignition tools drop me a note.

Seth Emerson

Check my new Performance Corvair Web site [www.perfvair.com]