Corvair DiagramCorvair Photo
Corvair Center
home forum corvairs calendar links Corvair Podcast
California Corvairs
Clarks Corvair
Clarks Corvair
“CORSA"



Chevy Corvair License Plate
Chevy Corvair Chrome Wheel
Corvair Center Forum :  Corvair Center Phorum The fastest message board... ever.
Corvair Center 
Picture Needed
Posted by: vairmech ()
Date: July 30, 2020 05:25PM

I need a good picture of a TransVair axle adapter like this one,



I can probably figure out the how to do it but a clear picture would sure help.

FYI, I know Clark's has adapters but I do not like the design.

I might be willing to purchase a set but then again afterwards I may see if anyone wants any made.

Thanks

Ken Hand
Handy Car Care
248 613 8586

Vairmech@aol.com

Options: ReplyQuote
Re: Picture Needed
Posted by: Phil Dally ()
Date: July 30, 2020 06:37PM

Not Transvair but should get you the six bolt pattern dimensions.

Attachments:


Options: ReplyQuote
Re: Picture Needed
Posted by: vairmech ()
Date: July 30, 2020 07:24PM

Thanks, but the VW/Porche part for the CV will already have the bolt pattern.

Ken Hand
Handy Car Care
248 613 8586

Vairmech@aol.com

Options: ReplyQuote
Re: Picture Needed
Posted by: Seth Emerson ()
Date: July 30, 2020 08:24PM

Ken, the Transvair kit had a small flat plate with two lumps welded into it to sit in the Corvair stub axle, in place of the inner U-joint. It used the four "Strap" holes to mount the plate to the stub axle, and presented a set of 6 bolt holes to attach the CV Joint. Crown sold the replacement yoke built to accept the stock CV joint, and mount into the 65-69 diff.

Seth Emerson

Check my new Performance Corvair Web site [www.perfvair.com]

Options: ReplyQuote
Re: Picture Needed
Posted by: vairmech ()
Date: July 31, 2020 04:07PM

Seth Emerson Wrote:
-------------------------------------------------------
> Ken, the Transvair kit had a small flat plate with two lumps welded into it to sit in the Corvair stub axle, in place of the inner U-joint. It used the four "Strap" holes to mount the plate to the stub axle, and presented a set of 6 bolt holes to attach the CV Joint. Crown sold the replacement yoke built to accept the stock CV joint, and mount into the 65-69 diff.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>

That is the second cheaper design and is what Clark's currently sells if they have any in stock.

I am after what I would consider a 1 piece adapter like is shown in the original picture.

I no one comes up with ny pictures I'll engineer something and it will be a one piece adapter for better rigidity for the CV joint.

Ken Hand
Handy Car Care
248 613 8586

Vairmech@aol.com

Options: ReplyQuote


Sorry, only registered users may post in this forum.
This forum powered by Phorum.