Rear hubs with backing plates, the bearings appear to be serviceable. $45.00
These hubs can be used on 66 to 69 cars if you reuse the spindle drive flange from your hub.
Torque control arms $25.00
Rear strut rods $20.00
Axles $15.00

forsale


4 sets available, all prices plus shipping from 95630



Edited 1 time(s). Last edit at 02/02/2019 07:33PM by MattNall.

Or, I've heard drill and tap the yoke flange for the 5/16" bolts on 66-69 models.

Frank DuVal

Fredericksburg, VA

got a picture of the rods?

Bob Bauer

Show-Me Corvairs

1966 Monza Convert 140 P/G with A/C, plastic wheel with tele-column am-fm posi-traction
1966 Corsa Convert 180 wood wheel tele-column am-fm sport steering posi-traction
1965 Corsa Coupe Crown V8 temporarily red lined for repair
House Springs, Missouri

I do not have a picture of the rods at this time. They are in good shape except for the bushings, they need replacing. The parts are 30 mi. from me and I will post photos when I get a chance to take them.

Pictures of the rear strut rods, as requested above.

Bump

In the process of replacing the strut rod bushing on my 65 corsa. The inter diameter of the of the inter steel sleeve is just under about .750 of an inch with a 1/2 inch bolt thru it. Is there a missing bushing that goes inside the inter steel bushing? If I use a poly bushing will the inter hole thru the poly bushing be 1/2 inch? If I make a bushing out of Nylatron (nylon impregnated with molybdenum disulphide) should the nylatron have a 1/2 inch hole in it? I have made shackles bushing for a old jeep out of Nylatorn and they worked fine. Just not sure why the 1/2 inch bolt does not contact the inter steel bushing. Thanks Larry

In reply to the above 3/4" is the correct diameter of the hole in the bushing. There is a washer with a shoulder that goes on either side of the bushing. The shoulder centers the 1/2" bolt in the bushing.

Westds Wrote:
-------------------------------------------------------
> There is a washer with
> a shoulder that goes on either side of the
> bushing. The shoulder centers the 1/2" bolt in the
> bushing.

Clarks Corvair C638X

---

Dave W. / Gilbert Arizona
65 Corsa 140/4
66 Corsa 140/4
66 Corsa 140/4 w/factory A/C
66 Corsa 455 Toro V8
65 Monza Convertible 110/4
66 Monza Convertible 140/4
65 Monza 4DR 140/PG w/factory A/C
65 Monza 4DR EJ20T/5

The plate that bolts to the body does have the 1/2 inch holes to center the bolt on the plate but nothing on the bushing. These washers must have worn out or not installed at the factory. Thanks for the part number I will order the washer when I order the bolt. Larry