Corvair DiagramCorvair Photo
Corvair Center
home forum corvairs calendar links Corvair Podcast
California Corvairs
Clarks Corvair
Clarks Corvair
“CORSA"



Chevy Corvair License Plate
Chevy Corvair Chrome Wheel
Corvair Center Forum :  Corvair Center Phorum The fastest message board... ever.
Corvair Center 
How to remove ignition switch?
Posted by: red64vair ()
Date: January 08, 2019 05:46PM

A friend lost ignition keys to his 63 and can't remove the switch. How is the switch removed without a key?

Larry Blaylock
Saltillo, Mississippi
64 convertible
66 customized Corsa coupe


Options: ReplyQuote
Re: How to remove ignition switch?
Posted by: TerribleTed ()
Date: January 08, 2019 06:12PM

it isn't without destroying it, unless a locksmith has some trick. key code off door lock cylinder should match ignition so perhaps a good locksmith can make a key from the code.

---------------------------------------------------------------------------------------------------------

Avid Corvair hobbiest since 1984.
I have personally performed ground up restoration on over 20 Corvairs.
I currently work full time at restoring and repairing Corvairs.
Located in the Atlanta Georgia area.
[www.facebook.com]

Options: ReplyQuote
Re: How to remove ignition switch?
Posted by: steve c goodman ()
Date: January 08, 2019 06:33PM

If glovebox is same remove the latch and go
to locksmith for a duplicate key. Don't tear
up a switch

best wishes, Steve
Rear Engine Spec. Inc. Golden, Colo.

1962 spyder 3.0L turbo---1965 Crown V8
1967 monza 110/4---1968 monza 110/4
1971 amante gt 110/4
CORSA/RMC/PPCC

Options: ReplyQuote
Re: How to remove ignition switch?
Posted by: Frank DuVal ()
Date: January 08, 2019 07:48PM

Right, door and glove box lock were the same code (and trunk) when the car was new. Of course things get changed sometimes.

Ignition cylinder captures screw on ring to prevent easy car theft.

Try every B10 blank (any GM car from 1935 to 1966) you can find and see if any allow the ignition cylinder to turn CCW, then insert paper clip and continue turning CCW. Cylinder comes out and the 4 digit code can be used by a locksmith to make new keys. I also can make them, but mail is slower than local locksmith.

To all, make sure you have TWO keys to every car you own!thumbs up Fix this now if you only have one key.

Locksmith opening lock is cheaper than destroying the lock and ring then having to rekey new cylinder to match. And taking glove box lock is best, no travel time for locksmith. Note DO NOT use a locksmith that thinks he needs to destroy the lock bezel to open a glove box lock. Code is on inner glove box cylinder, so it has to come apart. It can be opened by picking very easy. If you know the secret handshake.grinning smiley

Frank DuVal

Fredericksburg, VA

Options: ReplyQuote
Re: How to remove ignition switch?
Posted by: 67 airvair ()
Date: January 09, 2019 03:47AM

With replacement blanks, B10 and B11 are the same profile. Cars earlier than '65 use one key for all locks. Two keys are used on '65-up.

I do have locks available and can cut keys from the code or original keys.

-Mark

Options: ReplyQuote


Sorry, only registered users may post in this forum.
This forum powered by Phorum.